Luminex FLEXMAP 3D Hardware User Manual Manuel d'utilisateur télécharger pdf (Page 27)

FIGURE 12.

Fluidics Bay

1 Sheath filter

2 Tubing to sheath fluid container is attached here (blue)

3 Tubing to waste fluid container is attached here (orange)

Waste Fluid Container

The waste fluid container receives waste from the system. To maintain a stable flow rate, do

not move the waste line or container during system operation and make certain the waste

fluid container is properly vented. Place the container at least three feet below the surface on

which the instrument rests. You can place it as far away from the instrument as the tubing

allows. Never place it on top of the instrument. Refer to safety instructions for the waste fluid

container within the Fluidics section of the manual.

WARNING: Wear appropriate personal protective equipment when handling

parts that come into contact with potentially biohazardous

samples.

Mechanics

The mechanical subsystem of the FLEXMAP 3D instrument includes a filter system.

Replaceable ventilation filters clean the air used to cool the instrument and pressurize sheath

fluid. The four filters must be checked and cleaned as prescribed in the maintenance chapter

FLEXMAP 3D

Hardware User Manual

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 71 72

Pas de commentaire

Luminex FLEXMAP 3D Hardware User Manual Manuel d'utilisateur Page 27