Luminex IS 2.3 to xPONENT 3.1 Rev 2 Upgrade Instructions Manuel d'utilisateur

Luminex® IS Version 2.3 Upgrade Instructions to xPONENT® 3.1 Rev 2For In Vitro Diagnostic Use

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use65. Connect the serial end of the Luminex 100/200 serial

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use710. Select Luminex 100 IS. Click Change/Remove. In the

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use8Release Notes – Click to view contact information, inst

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use99. A dialog box opens with two installation options, Co

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use1011. Select an installation folder for the software. Cl

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use11Verify Firmware Version Verify that the correct firmwa

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use12Luminex Contact InformationContact Luminex Technical S

© LUMINEX CORPORATION, 2001-2011. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, or translated into any

iContentsUpgrade Procedure ...1Important Upgrade Information...

ii

1Upgrade Procedure

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use2Important Upgrade InformationBefore performing the Lumi

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use3Training To register or find out more about Luminex xPO

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use4• Luminex xPONENT 3.1 Rev 2 Software Manual on CD These

Luminex IS Version 2.3 Upgrade Instructions to xPONENT 3.1 Rev 2 - For In Vitro Diagnostic Use56. In the Save As dialog box that opens, select the fol