Luminex 100 IS Developer Workbench Guide Version 2.3 Manuel d'utilisateur télécharger pdf (Page 23)

xMAP Technology Create Template

PN 89-00002-00-084 Rev. B 17

Figure 6. The Product Name column shows all saved products

you created. Select the desired product from the list.

Figure 6. Open Reagent Products Dialog Box—Add a Standards Product

10. Highlight the product to add to the template; the associated test

and reagent information displays for your reference. You cannot

edit this information here. If the desired product is not present in

the list, select New to create a new product. Click Open.

11. The system applies the product (standards, controls, or both) to

the template. If desired, edit the Test Name and Test Units.

Select Apply Unit to apply the same unit that you entered in the

first line to all tests.

12. At the Select Bead IDs wizard, select the Bead ID for each test

listed. See Figure 7. Type the Bead ID or select it from the drop-

down chart (optionally, select the first bead ID then click Apply

Bead ID Increment + 1 to auto-fill the remaining entries with

sequential bead IDs).

Note: You can use the same

product in multiple templates.

However, you are only allowed to

use one product per template.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 73 74

Pas de commentaire

Luminex 100 IS Developer Workbench Guide Version 2.3 Manuel d'utilisateur Page 23