Luminex xPONENT 4.2 for FLEXMAP Manuel d'utilisateur télécharger pdf (Page 101)

• Replicate Count - Defines a quantity of replicate sets from one to nine.

• Grouping - Selects the sequence in which the replicates are laid out in plate wells. The

options are:

• 123123123 - This displays one of each replicate set at a time in numerical order.

• 111222333 - This displays all the replicates in a set before moving on to the next set in

numerical order.

You can assign the following well commands. Each command is associated with a color. You

can click and drag to highlight a series of wells, click a column or row header to highlight the

entire column or row, or simply click and highlight different wells and then click a command

below to assign that command to all the highlighted wells.

• Unknown (U): Yellow

• Background (B): Purple

• Control (C): Red

• Standard (S): Green

The Delete and Start at Well commands are also available to assign as well commands.

Delete removes the well command for the selected well. The Start at Well command enables

you to begin acquisition at a well other than A1.

NOTE: You should first delete all standards from the plate layout if any of

the standards need to be rearranged, and all controls from the plate

layout if any of the controls need to be rearranged.

NOTE: Wells and routine names you assign to the protocol plate layout are

saved into the protocol settings. The routine itself must exist on the

instrument. Standards and controls associated with a given protocol

typically remain constant, while the number of unknown wells often

vary. You can assign a specific number of unknown wells to the plate

when setting up a batch.

Commands and Routines - Assigns maintenance commands and routines to a well after

you select it in the Command Sequence area.

• Add - Opens the Commands and Routines dialog box so you can select a command or

routine.

•

• Delete - Deletes the selected command or routine.

• Post Batch Routine - Opens the Commands and Routines dialog box so you can select

a post-batch command or routine.

Protocols Page

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 147 148

Pas de commentaire

Luminex xPONENT 4.2 for FLEXMAP Manuel d'utilisateur Page 101