Luminex xPONENT 4.2 for FLEXMAP Manuel d'utilisateur télécharger pdf (Page 76)

• Plate Layout - Opens the Report dialog box, which contains the Batch Plate Layout

Report.

• Approve - Opens the Batch Approval Confirmation dialog box to approve the selected

batch.

Only approved batches can be transmitted to the LIS. If your software is licensed for LIS

use, you can transmit batches to the LIS from the Sample Results tab. After you have

approved a batch, the status of the batch changes to Approved in the Complete Batches

list.

• Exp Results - Opens the Save As dialog box to choose an export destination for the .CSV

file containing your results.

• Import - Opens the Open dialog box so you can select a batch file (.mdf) to import. Select

Include Raw Files (LXB) to include raw files in the import. Select Overwrite to overwrite

existing files.

• Export - Opens the Export Batch dialog box, where you can choose a location for the file

you selected to export. Select Include Raw Files (LXB) to include raw files in the export.

Select Overwrite to overwrite existing files.

• Replay - Opens the Select Replay Mode dialog box. This box enables you to use the data

stored in the run files from the initial acquisition to reprocess a batch, creating a new batch

output file. A batch can be reprocessed multiple times. When you replay or recalculate a

batch, you perform the same steps to create the batch as you did when you created the

batch the first time. This sequence varies based on whether or not you created a new

batch from a new protocol or a new batch from an existing protocol. The initial batch data

and output file always remain intact and unchanged. Each time you replay a batch, the

system handles it as if it is new data, and creates a separate batch entry and output file.

• Replay batch - Use to replay raw bead data files. The bead data files are replayed

using the gate, analyte, analysis settings, and plate layout that were selected in the new

or updated protocol. Settings such as bead type, volume, timeout, XY heater, and report

gain have no effect on the replayed results.

xPONENT

for FLEXMAP 3D

1 2 ... 71 72 73 74 75 76 77 78 79 80 81 ... 147 148

Pas de commentaire

Luminex xPONENT 4.2 for FLEXMAP Manuel d'utilisateur Page 76