Luminex FLEXMAP 3D User Manual Manuel d'utilisateur télécharger pdf (Page 50)

4. Check both of the fuses in the cartridge for damage. A fuse can display physical

evidence of damage, for example, broken wire or blackened glass; if it displays no

physical evidence, test it for continuity with a voltmeter.

Replace damaged fuses with the type specified on the sticker to the right of the power

input module.

6. Replace the red cartridge.

7. Shut the module door.

8. Plug in the power cord and turn on the FLEXMAP 3D

instrument.

NOTE: If your FLEXMAP 3D

instrument is not on a swivel base and it

requires moving in order for you to access the back of the

instrument, use the software to re-calibrate and re-verify the

instrument after it is restored to its original location.

FIGURE 21.

Back of the FLEXMAP 3D

Instrument

1 Power Module

2 Location to insert screwdriver to open module door, as referenced in Step 2

3 Fuse Information

Maintenance Logs

Use the Maintenance Logs (located in Appendix E) to record maintenance information. Fill in

the dates in the first line of the table. The first table includes a sufficient number of columns

for one week (7 days). The second table includes a sufficient number of columns for monthly

Luminex

FLEXMAP 3D

Hardware User Manual

For research use only. Not for use

in diagnostic procedures.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 85 86

Pas de commentaire

Luminex FLEXMAP 3D User Manual Manuel d'utilisateur Page 50