Luminex xPONENT for MAGPIX 4.2 Manuel d'utilisateur télécharger pdf (Page 50)

Clicking either Pre Batch Routine or Post Batch Routine opens the Commands and

Routines dialog box, where you can select the command or routine you want before or after

running the batch. Clicking Add after selecting a well opens the same box for you to select a

command or routine for that well. Clicking Delete after selecting a well deletes any

commands or routines associated with that well.

• Plate - Specifies the plate to display in the plate image in the list. Add Plate adds a new

plate to the batch, and Delete Plate deletes the plate highlighted in the list.

• Direction - Specifies the direction to run the plate commands. Select either horizontally or

vertically. The selected direction also dictates how wells are added to the plate when

assigning multiple unknowns, standards, and controls at one time.

• Plate Navigation - Displays a smaller plate image for the current batch.

• Single Step - Instructs the system to acquire one well and then stop. Use this to ensure

the system is working correctly before you run the whole batch.

• Off Plate Area - Designates an alternate location for maintenance commands in the

Commands and Sequence list.

• Save Prtcl - Opens the Save Protocol dialog box to save the protocol and/or kit.

• Select Save Protocol and/or Save Std/Ctrl Kit to save the protocol and/or kit.

• Type information in the following boxes and click Save to save the protocol or kit.

• Protocol Name

• Version

• Manufacturer

• Optional Description

• Std/Ctrl Kit Name

• Std/Ctrl Kit Lot#

• Expiration

• Manufacturer

• Lots

• Save - Saves the information as a pending batch.

• Cancel - Returns to the Batches tab.

• Back - Returns to the previous window.

• Run Batch - Runs the batch and opens the Current Batch tab, where you can monitor the

batch as it runs.

Create a New Batch from a New Protocol

Click this option to create a new batch from a new protocol. This option enables you to create

a protocol while you are creating the batch.

1. Open the Batches page.

2. Click Create a New Batch from a new protocol to open the Settings tab.

3. Type a name in the Name box.

4. Type a description in the Description box.

Batches Page

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 163 164

Pas de commentaire

Luminex xPONENT for MAGPIX 4.2 Manuel d'utilisateur Page 50