Luminex IS Version 2.3 Manuel d'utilisateur télécharger pdf (Page 44)

Luminex IS Software Manual for Version 2.3 xMAP Technology

34 PN 89-00002-00-110 Rev. B

Test Sort Orders This command is in the Data Export Tab of the Options tab. You can

select Alphabetical by test name, Sequential by Region ID, or by

Template Setup Order

• Alphabetical by Test Name - the tests are sorted by

alphabetical order

• Sequential by Region ID - the tests are sorted numerically by

bead ID#.

• Template Setup Order - the tests are sorted n the order set up

in template, regardless of name or ID.

Validate Control Opens the Validate Control dialog box. In this box, you choose to

validate all control tests (click Yes), or only a single test (click No).

Validate Standard Opens the Validate Standard dialog box. In this box, you choose to

validate all control tests (click Yes), or only a single test (click No).

View Batch Data Click to open a previously acquired batch that is stored in the

database. You cannot view New Advanced Batches.

Warmup Warms up the system to prepare the optics prior to sample

acquisition. The system automatically begins warming up when you

turn power on; however, you will need to use the Warmup command

if the system is idle for four hours or longer.

Wash Washes fluidics line. Sends fluid (distilled water) through the fluidic

lines in the system. Pulls the fluid from a well or the reservoir and

runs it completely through the system to the waste receptacle.

Zoom Zooms or enlarges a specific area on the histogram or dot plot

display. Click and drag right to left to adjust the graph’s range.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 119 120

Pas de commentaire

Luminex IS Version 2.3 Manuel d'utilisateur Page 44