Luminex IS Version 2.3 Manuel d'utilisateur télécharger pdf (Page 67)

xMAP Technology Luminex 2.3 Software

PN 89-00002-00-110 Rev. B 57

Figure 31 Processing Multiple Plates

After the first microtiter plate in a multiple plate batch has been

acquired, the system pauses and prompts you to insert the next plate.

 To process multiple plates during a batch or multi-batch:

1. Create the batch or multi-batch. See “Create a New Batch” on

page 49 or “Create a Multi-Batch” on page 54.

2. Insert the first plate.

3. On the Run Batch tab, click Start Plate to begin processing the

batch. When the initial plate is through, the system pauses and

displays the Insert Next Plate message in red underneath the

sheath pressure gauge.

4. Click Eject, then remove the acquired plate and load the next

plate for processing.

5. Click Resume. The system resumes the acquisition process.

Re-Run or

Recover

Incomplete Batch

An incomplete batch can be caused by situations such as a power

failure, software failure, marking a batch for deletion, or clicking

Cancel All. Use this procedure to re-run or recover an incomplete

batch.

 To open an incomplete batch:

1. On the File Menu, click Open Incomplete Batch. The Open

Run dialog box opens. Select the batch you wish to recover from

the list.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 119 120

Pas de commentaire

Luminex IS Version 2.3 Manuel d'utilisateur Page 67