Luminex FLEXMAP 3D Hardware User Manual Manuel d'utilisateur télécharger pdf (Page 64)

1 Power Inlet 2 PC Communications plug (USB type B)

3. Connect the USB communications cable between the FLEXMAP 3D instrument (P1) and

the PC, and connect the power cables for the PC, monitor, and FLEXMAP 3D instrument

to outlets but do not turn on any of the devices.

4. Place the sheath container below the instrument with the container opening facing up.

5. Remove the existing container cap and install the cap from the blue tubing accessory in

its place.

6. Connect the blue sheath line to both the disconnect on the sheath container and the blue

connector on the outside of the instrument.

FIGURE 26.

Sheath and Waste Container Connections

7. Place the empty waste container below the instrument with the container opening facing

up.

8. Remove the existing container cap and install the cap from the orange tubing accessory

in its place.

9. Connect the orange waste line to both the disconnect on the waste container and the

orange connector on the outside of the instrument.

10. Open the two front access doors.

11. Turn on the FLEXMAP 3D instrument using the power switch on the right side of the

instrument, toward the back.

12. Observe the indicators associated with powering up a FLEXMAP 3D instrument.

13. Visually inspects for leaks.

14. Turn on the PC and monitor.

15. Close the access doors.

16. If the system includes a touch screen monitor, test it by touching the screen. The mouse

cursor should move to the location you touched. If monitor does not respond, use the

supplied CD to install the drivers. If the mouse cursor responds correctly, calibrate the

monitor using the software preloaded onto the PC.

17. Access the Luminex xPONENT software on the PC and confirm that the instrument is

communicating with the software.

Installation

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 70 71 72

Pas de commentaire

Luminex FLEXMAP 3D Hardware User Manual Manuel d'utilisateur Page 64