Luminex IS Version 2.3 Manuel d'utilisateur télécharger pdf (Page 73)

xMAP Technology Luminex 2.3 Software

PN 89-00002-00-110 Rev. B 63

•Select Total Beads to continue analyzing until the selected

beads meet total beads value. Use Total Beads when you are

not using all of your selected bead sets in each well. Set the

total to desired high value.

6. Click the Bead Set tab. Select the checkboxes next to each

desired bead set for this batch. Click Select All to select all the

listed bead sets, or Deselect All to deselect all selected bead sets.

Figure 36 Options Dialog Box—Bead Set Tab

7. Edit the Events and Caption information for each bead set. Edit

the Default Events box to change the default value. Click Apply

to All to apply the default value to all bead sets. Table 8 lists

selection shortcuts.

Table 8. Bead Set Tab - Selection Shortcuts

Selected Column Select by clicking in the box.

Events Column Select desired field and right-click.

The value displayed in the “Default

Events” box updates the selected

field when you click “Apply Default”.

Caption Column If names are defined under this

column, you can right-click selected

rows and “Reset” back to normal

defaults.

Entire Column Select an entire column by clicking

the column heading (Selected,

Events, or Caption).

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 119 120

Pas de commentaire

Luminex IS Version 2.3 Manuel d'utilisateur Page 73